MEDPRO (Media Processor MAPD Circuit Pack)
Issue 5 October 2002
1383
555-233-119
Table 355.
TEST #1379 Ping Test
Error
Code
Test
Result
Description/ Recommendation
1, 2
ABORT
Internal Error.
1. Retry the command at 1-minute intervals a maximum of 3 times.
7
ABORT
Destination unreachable.
1. Verify that at least one destination reachable through this port is
up.
2. Repeat the test.
3. If the test still aborts, escalate the problem.
2000
ABORT
Response to the test was not received from the Media Processor
circuit pack within the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit pack.
Reset the circuit pack by issuing the busyout board UUCSS and
the reset board UUCSS commands.
2. If this result occurs again, replace the circuit pack.
2012
ABORT
Internal system error.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2100
ABORT
The necessary system resources to execute the test could not be
allocated.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2500
ABORT
Internal system error.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2801
ABORT
No IP address defined. Verify IP Interfaces translations and retest.
2802
ABORT
Different IP address pinged than software had allocated for the test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2805
FAIL
The number of pings received did not match the number sent
(normally one ping sent). This means that no ping responses were
received from the gateway defined on the ip-interfaces form for the
Media Processor.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2807
ABORT
The board is administered, but not enabled in the change
ip-interfaces form.
Continued on next page