555-233-119
1148
Issue 5 October 2002
System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order presented in the table below when inspecting
errors in the system. By clearing error codes associated with the Tone Detection
Verification Test, for example, you may also clear errors generated from other
tests in the testing sequence.
Tone Detection Verification Test (#42)
This test verifies the "touch-tone digits detection" capability of the DTMR port is
functioning properly.
Order of Investigation
Short Test
Sequence
Long Test
Sequence
D/ND
1
1.
D = Destructive; ND = Nondestructive
Tone Detection Verification Test (#42)
X
X
ND
Tone Detector Audit/Update Test (#43)
X
X
ND
Table 246.
TEST #42 Tone Detection Verification Test
Error
Code
Test
Result
Description/ Recommendation
none
ABORT
The system was not able to allocate all the resources needed for this test or
there was an internal system error.
1
ABORT
The system could not allocate all the resources needed to test the DTMR
port.
1001
ABORT
The system was unable to put the DTMR port in the appropriate mode to
test it.
1002
ABORT
The system could not allocate time slots for the test connection. This could
happen when the system is heavily loaded. If the system is not heavily
loaded, then test the TDM Bus via the test tdm [a|b] command. Refer to
the TDM-BUS (TDM Bus) Maintenance documentation for details.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page