AN-LN-PT (Analog Line Port)
Issue 5 October 2002
683
555-233-119
Battery Feed Test (also called Port Diagnostic
Test) (#35)
The battery feed chip provides power to the telephone equipment, signaling,
rotary dial pulsing, transmission, and balance. This test checks the signaling and
switchhook capabilities of the battery feed chip by terminating the port, applying
battery power, and detecting the resulting current.
Table 52. TEST #35 Battery Feed Test
Error
Code
Test
Result
Description/Recommendation
ABORT
Necessary system resources could not be allocated to run this test.
1. Retry the command at 1-minute intervals no more than 5 times.
2. If the test continues to abort, escalate the problem.
1000
ABORT
System resources are unavailable. The port may be busy with a valid call.
This result is also reported for the system’s Music-On-Hold port when it is
off-hook, which it usually is.
1. Use display port UUCSSpp to determine the station’s extension.
2. Use status station extension to determine the service state of the
port.
3. If the port is in use, wait until the port is idle. Retry the command at
1-minute intervals no more than 5 times.
4. If the test continues to abort, escalate the problem.
1004
ABORT
A valid call seized the port during the test and aborted the test.
1. Use display port UUCSSpp to determine the station extension.
2. Use status station extension to determine the service state of the
port.
3. If the port is in use, wait until the port is idle before testing. Retry the
command at 1-minute intervals no more than 5 times.
4. If the test continues to abort, escalate the problem.
1005
ABORT
This test was aborted due to a configuration problem. The test is not
applicable for this type of analog port. This error can be ignored.
1018
ABORT
Test has been disabled via administration. The default for the
Test
field
on the Station screen is y. Determine why this field has been set to
n
for
this station. It may be due to application Test #48, which can disturb users
or terminal operations.
1. To enable the test for the station being tested, enter change station
extension and set the
Test
field to y.
Continued on next page