Maintenance Objects
1368
Issue 5 October 2002
Loss of Signal Alarm Inquiry Test (#138)
This test is meaningless for the TN802 MAPD circuit pack.
Table 341
details the
test results.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This could be
due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Execute the add ds1
UUCSS command to administer the MAPD interface if it is not already
administered.
2. If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the board
is shut down. Reseating the board re-initializes the board.
3. If the board was found to be correctly inserted in step 1, then issue the
busyout board command.
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the linkage between the internal ID and the port.
Table 341.
Loss of Signal Inquiry Test (#138) results
Windows NT
up on the
TN802?
Then
Cause
Y
Test passes
Y
Test aborts with ABORT
2000 Error Code.
Windows NT is not communicating
with the angel firmware.
N
Test aborts with ABORT
2000 Error Code.
Windows NT down.
Table 340.
TEST #53 SAKI Sanity Test —
Continued
Error
Code
Test
Result
Description/ Recommendation
Continued on next page