Maintenance Objects
555-233-119
636
Issue 5 October 2002
Loop Around Test (#161)
This test is designed to check the on-board transmission capabilities of the NPE
on the analog port.
1018
ABORT
Test disabled by administration. This only applies to analog stations.
1. To enable the test for the analog station being tested, enter change
station extension and set the Test field to y.
2000
ABORT
Response to the test request was not received within the allowable time
period.
2100
ABORT
Could not allocate the necessary system resources for this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Any
FAIL
The NPE of the tested port did not conference the tones correctly. This
causes noisy and unreliable connections.
1. Replace the circuit pack.
PASS
The port can correctly conference multiple connections. User-reported
troubles on this port should be investigated by using other port tests and by
examining station, trunk, or external wiring.
Table 36. TEST #161 Loop Around Test
Error
Code
Test
Result
Description/ Recommendation
ABORT
Could not allocate the necessary system resources for this test. Try (a).
1000
ABORT
System resources required to run this test are not available. The port may be
busy with a valid call. Use display port PCSSpp to determine the station
extension. Use status station to determine the service state of the port. If
the port is in use, wait until it is idle before testing.
1. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
Continued on next page
Table 35. TEST #7 Conference Circuit Test —
Continued
Error
Code
Test
Result
Description/Recommendation
Continued on next page