test card-mem
Issue 5 October 2002
537
555-233-119
test card-mem
Use test card-mem to run a sequence of tests on the memory card in the
specified switch processor element. The test sequences in order for both long and
short options are listed in the following table:
These tests verify the sanity of the memory card device, the basic
read/erase/write operations to the memory card, the integrity of the translation
data stored in the memory card, the function of 12 volt power supply in TN777B
NETCON circuit pack used for memory card erase/write operations, the
translation capacity of the memory card, and the consistency of data stored in
both memory cards in a High or Critical Reliability system. This command can
also help troubleshoot the following hardware errors: CARD-MEM, CAP-MEM,
and FL-DATA.
Test
Short
Long
Memory Card Insertion Test (#695)
X
X
Memory Card Format and Read Test (#696)
X
X
Memory Card Match Test (#697)
X
X
Memory Card Write-Protected Test (#698)
X
X
Memory Card Directory Recovery Test (#699)
1
1
If the directories match, this test runs normally. If the directories do not
match, this test attempts to correct the mismatch, and if the flash card is
an old 12V flash card, the attempt at correction fails.
X
X
Memory Card Translation Data Integrity Test (#694)
X
Memory Card Erase/Write/Read Test (#693)
2
2
This test fails with old 12V cards, although those cards can indeed be
read.
X
Memory Card Capacity Test (#1014)
X
Flash Data Consistency Test (#421)
X
3
3
The “Flash Data Consistency Test” is not executed in simplex systems.