SEC-CDR (SEC-CDR Link Maintenance)
Issue 5 October 2002
1587
555-233-119
Speech Synthesis Parameter Update Test (#169)
This test updates the DTMF interdigit time-out parameter used by the Speech
Synthesis circuit pack to be consistent with that specified by the switch processing
element (SPE).
SEC-CDR (SEC-CDR Link
Maintenance)
The SEC-CDR (SEC-CDR Link) maintenance strategy is covered in the
PRI-CDR/SEC-CDR (PRI-CDR Link) Maintenance documentation.
Table 454.
TEST #169 Speech Synthesis Parameter Update Test
Error
Code
Test
Result
Description/ Recommendation
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000
ABORT
System resources required to run this test are not available. The port may be
busy with a valid call and therefore unavailable for certain tests. You must wait
until the port is idle (yellow LED if off) before retesting.
1. If the port is idle, retry the command at 1-minute intervals a maximum of 5
times.
2100
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Any
FAIL
An internal system error has occurred.
PASS
The DTMF interdigit time-out parameter has been updated.
1. User-reported troubles should be investigated using other tests and by
verifying that other ports on this circuit pack are working correctly.
Continued on next page
MO Name (in Alarm
Log)
Alarm Level
Initial Command to Run
Full Name of MO
PRI-CDR/SEC-CDR
MINOR
test cdr-link primary/secondary l
CDR Link
PRI-CDR/SEC-CDR
WARNING
test cdr-link primary/secondary
CDR Link