Maintenance Objects
555-233-119
632
Issue 5 October 2002
Error Log Entries and Test to Clear Values
Notes:
a.
Error Type 0 - Run the Short Test Sequence first. If all tests pass, run the Long Test
Sequence. Refer to the appropriate test description and follow the recommended
procedures.
b.
Minor alarms on this MO may be downgraded to Warnings based on the values in
set options.
c. Error type 1 is an in-line error and can only be resolved over time. This
indicates that no terminal equipment was present when ringing was
attempted. Use the short test port PCSSpp.
d. Error type 23 - The circuit pack has been logically administered but not
physically installed. The alarm will be cleared when the circuit pack is
installed.
e. Error type 130 - The circuit pack has been removed or has been insane for
more than 11 minutes. To clear the error, reseat or replace the circuit pack.
f. Error type 257 is an in-line error and can only be resolved over time. This
error indicates that ringing voltage is absent. If only 1 analog circuit pack in
the system has this problem, replace the circuit pack. If all analog circuit
packs have this error, check the ringing generator.
g. AUDIX is not available to the switch. Check the AUDIX system, referring to
EMBEDDED AUDIX System Maintenance, 585-300-110.
h. The TDM bus is out of service. See the “TDM-BUS” section.
Error
Type
Aux
Data
Associated Test
Alarm
Level
On/Off
Board
Test to Clear Value
0 (
a
)
0
Any
Any
Any
test port PCSSpp sh r 1
1 (
c
)
40977
None
18
0
busyout station
<extension>
WRN
ON
release station extension
23 (
d
)
0
None
WRN
OFF
130 (
e
)
None
WRN
ON
test port PCSSpp sh
257 (
f
)
40973
None
513 (
g
)
Any
None
1025
(
h
)
Loop Around Test
(#161)
MIN/ WRN
b
ON
test port PCSSpp l r 2
1281
Conference Test (#7)
MIN/ WRN
b
ON
test port PCSSpp l r 2
1537
NPE Crosstalk Test (#6)
MIN/ WRN
b
ON
test port PCSSpp l r 2