555-233-119
1196
Issue 5 October 2002
FTP the new firmware image file
The following steps are generic to most FTP programs. Use your laptop/PC/UNIX
to complete this procedure.
1. Ensure that the new firmware image file is in the same directory from which
you will launch the FTP session.
2. Type ping <source_ip_address> and press
Enter
to verify a
communication link to the source board.
3. Type ftp <source_ip_address> and press
Enter
.
4. Log in to the source circuit pack with the same ftplogin and ftppassword
that you used in the
‘‘Set up file system on circuit pack’’
section.
■
ftplogin is any temporary login for this FTP session, for example,
denver.
■
ftppassword is any temporary login for this FTP session, for
example, broncos.
5. Type bin and press
Enter
.
This transfers files in binary format.
6. If you are downloading to the TN2501AP (VAL) circuit pack only, type cd /
and press
Enter
.
This command moves you from the announcement directory (default for
FTP sessions) to the root directory (/) where firmware and other files are
located.
7. Type put <filename.ext> and press
Enter
.
This command copies the new firmware image file to the destination
directory.
Type dir and press
Enter
.
Verify that the new firmware image file is on the circuit pack.
8. Type quit and press
Enter
.
This ends the FTP session.
Verify files
From the SAT verify that the new firmware image file is on the circuit pack.
1. Type list directory board <UUCSS> and press
Enter
.
The List Directory screen (
Screen 75
) displays.
2. Verify that the new firmware image file is listed in the
File/Directory
Name
field.