DIG-BD (Digital Line Circuit Pack)
Issue 5 October 2002
1013
555-233-119
DIG-BD (Digital Line Circuit Pack)
Refer to XXX-BD (Common Port Circuit Pack) Maintenance documentation for
circuit pack level errors. See DIG-LINE (Digital Line) Maintenance documentation
for related line information.
0
NO
BOARD
The test could not relate the internal ID to the port (no board).
1. Check to ensure that the board translations are correct. Translate the
board, if necessary.
2. Issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board command. This should re-establish the linkage
between the internal ID and the port.
MO Name (in
Alarm Log)
Alarm
Level
Initial Command to Run
1
1.
Where P is the port network number (1 for PPN); C is the carrier designation (for
example, A, B, or C); and SS is the address of the slot in the carrier where the circuit
pack is located (for example, 01, 02, etc.).
Full Name of MO
DIG-BD
MIN
test board PCSS sh
Digital Line Circuit Pack
DIG-BD
WRN
test board PCSS sh
Digital Line Circuit Pack
Table 192.
TEST #36 Port Audit Update Test — Continued
Error
Code
Test
Result
Description/ Recommendation
Continued on next page