ADX16A-PT (AUDIX Analog Line/Control Link)
Issue 5 October 2002
635
555-233-119
Conference Circuit Test (#7)
This test verifies that the NPE channel for the port being tested can correctly
perform the conferencing function.
2000
ABORT
Response to the test request was not received within the allowable time
period.
2012
ABORT
System could not respond to this request.
2100
ABORT
Could not allocate the necessary system resources for this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Any
FAIL
The NPE of the tested port was found to be transmitting in error. This
causes noisy and unreliable connections.
1. Replace the circuit pack.
PASS
The port is correctly using its allocated time slots. User-reported troubles on
this port should be investigated by using other port tests, by examining
station wiring, or by examining the station.
Table 35. TEST #7 Conference Circuit Test
Error
Code
Test
Result
Description/Recommendation
ABORT
Could not allocate the necessary system resources to run this test. (a)
1000
ABORT
System resources required to run test are not available. The port may be
busy with a valid call. Use display port PCSSpp to determine the station
extension. Use status station to determine the service state of the port. If the
port is in use, wait until it is idle before retesting.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1004
ABORT
The port was seized by a valid call during the test. The test has been aborted.
Use display port PCSSpp to determine the station extension. Use status
station to determine the service state of the port. If the port is in use, wait
until it is idle before testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Table 34. TEST #6 NPE Crosstalk Test —
Continued
Error
Code
Test
Result
Description/ Recommendation
Continued on next page