Maintenance Objects
555-233-119
672
Issue 5 October 2002
Station Present Test (also called Ringing
Application Test) (#48)
Test #48 applies momentary ringing voltage to terminal equipment and monitors
resulting current flow to determine whether the equipment is connected to the
port.
Test #48 may cause some terminal equipment to ring briefly during daily
maintenance. If this disturbs the user or the phone equipment, to disable Test #48
use change station
extension
and set the
Tests
field to n. On some software
releases, this will also disable Tests #6, 7, 35, 47, and 161.
Table 49. TEST #48 Station Present Test
Error
Code
Test
Result
Description/ Recommendation
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000
ABORT
System resources required to run this test were not available. The port
may be busy with a valid call.
Use display port PCSSpp to determine the station’s extension. Use
status station extension to determine the service state of the port. If the
port is in use, it will be unavailable for certain tests. Wait until the port is
idle before retesting.
1. If the port is idle, retry the command at 1-minute intervals up to 5
times.
2. Check for phone left off-hook or for wiring problems.
1004
ABORT
System resources required to run this test are not available. The port may
be busy with a valid call. Use display port PCSSpp to determine the
station extension. Use status station to determine the service state of the
port. If the service state indicates that the port is in use, the port is
unavailable for certain tests. (Refer to the “Status Commands” section in
Chapter 8, “Maintenance Commands and Trouble-Clearing Aids”, for a full
description of all possible states.) Wait until the port is idle before retesting.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1005
ABORT
The test was aborted due to a configuration problem. This code will result
under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the modem pool
member or music on hold).
2. The circuit pack is one of the following:
— TN742 vintages 13, 14 and 15
— TN769 vintages 3, 4 and 5
Continued on next page