ADX16A-PT (AUDIX Analog Line/Control Link)
Issue 5 October 2002
637
555-233-119
1002
ABORT
The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors. Refer to “TDM-BUS” to diagnose TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic, try
(a).
1003
ABORT
The system could not allocate a tone receiver for the test. The system may
be oversized for the number of tone detectors present or some tone
detectors may be out-of-service.
1. Resolve any “TTR-LEV” errors.
2. Resolve any “TONE-PT” errors.
3. If neither condition exists, retry the command at 1-minute intervals a
maximum of 5 times.
1004
ABORT
The port was seized by a valid call during the test. The test has been
aborted. Use display port PCSSpp to determine the station extension. Use
status station to determine the service state of the port. If the port is in use,
wait until the port is idle before testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1018
ABORT
Test disabled by administration. To enable the test for the particular analog
station being tested, enter change station extension and set the Test field
to y.
2000
ABORT
Response to the test request was not received within the allowable time
period.
2100
ABORT
Could not allocate the necessary system resources for this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL
The reflective Loop Around Test failed. This causes noisy or unreliable
connections or other users calling this port may hear an echo.
1. Replace the circuit pack.
PASS
The port is able to provide an analog transmission path to the station
equipment. User-reported troubles on this port should be investigated by
using other port tests, by examining station wiring, or by examining the
station.
Table 36. TEST #161 Loop Around Test —
Continued
Error
Code
Test
Result
Description/ Recommendation
Continued on next page