AN-LN-PT (Analog Line Port)
Issue 5 October 2002
685
555-233-119
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port’s message lamp state (if it has one) and
translations with information in the software.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This result
could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, or an insane board is inserted.
1. Check to make sure that the board translations are correct. Use list
configuration, and resolve any problems.
2. If the board is correctly inserted, use busy board UUCSS.
3. Issue reset board UUCSS.
4. Issue release board UUCSS.
5. Issue test board UUCSS long. This re-establishes the link between
the internal ID and the port.
6. If this is not the case, check to make sure that a valid board is inserted.
Table 53. Test #36 Station Status and Translation Audits and Updates
Error
Code
Test
Result
Description/ Recommendation
ABORT
Necessary system resources could not be allocated to run this test.
1. Retry the command at 1-minute intervals no more than 5 times.
2. If the test continues to abort, escalate the problem.
1004
ABORT
A valid call seized the port during the test and aborted the test.
1. Use display port UUCSSpp to determine the station extension.
2. Use status station extension to determine the service state of the
port.
3. If the port is in use, wait until the port is idle before testing. Retry the
command at 1-minute intervals no more than 5 times.
4. If the test continues to abort, escalate the problem.
1005
ABORT
This test was aborted due to a configuration problem. The test is not
applicable for this type of analog port. This error can be ignored.
Continued on next page
Table 52. TEST #35 Battery Feed Test —
Continued
Error
Code
Test
Result
Description/Recommendation
Continued on next page