MEDPRO (Media Processor MAPD Circuit Pack)
Issue 5 October 2002
1375
555-233-119
Error Log Entries and Test to Clear Values
Notes:
a. Error Type 1 - indicates that the circuit pack has totally stopped functioning
or is not fully administered. The alarm is logged about 15 minutes after the
circuit pack has been removed or 11-minutes after the
SAKI
Test (#53) fails.
To be fully administered, a MedPro circuit pack must meet all of these 4
conditions:
1. Have an entry in the circuit pack form (change circuit pack)
2. Have the MedPro IP address administered (change node-names)
Table 350.
DS1 Interface Circuit Pack Maintenance Error Log Entries
Error
Type
Aux
Data
Associated Test
Alarm
Level
On/Off
Board
Test to Clear Value
0
1
1.
Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
0
Any
Any
Any
test board UUCSS
1(a)
0
Circuit pack removed or SAKI
Test (#53)
MIN/WRN
2
2.
If ports are assigned to the circuit pack, then a minor alarm is raised. If no ports are assigned to the
circuit pack, then a warning alarm is raised. The alarm is raised after the circuit pack has been
missing for a period of 15 minutes. Warning alarms are also raised against any ports administered
on the circuit pack.
ON
18(b)
0
busyout board UUCSS
WARNING
OFF
release board UUCSS
23(c)
0
WARNING
OFF
add ds1 UUCSS
125(d)
None
None
MIN/WRN
3
3.
Minor alarms on this MO may be downgraded to warning alarms based on values set in the set
options command.
ON
257(e)
65535
Control Channel Loop Test
(#52)
MINOR
ON
test board UUCSS l r 2
1538(f)
Any
Hyper activity
MIN/WRN
3
ON
1793
Any
NIC Loss Of Signal
MIN/WRN
3
test board UUCSS l r 2
2049(g)
Any
NT PC Failure
MIN/WRN
3
reset board UUCSS
2305
Any
IP Address Inconsistency
test board UUCSS l r 2
2561
Any
Ping Error
MIN/WRN
3
test board UUCSS l r 5
3841(h)
4358
Log Only
3999(i)
Any
None
Continued on next page