RANL-STA (Remote Analog Line (Station) Port)
Issue 5 October 2002
1551
555-233-119
Station Present Test (also called Ringing
Application Test) (#48)
This test applies momentary ringing voltage to the terminal equipment and
monitors resulting current flow to determine whether the terminal equipment is
connected to the port. The test may cause some terminal equipment to ring briefly
during daily maintenance. If this ringing disturbs the customer or the terminal
equipment, disable it via the
Tests
field on the change station form. However,
on some software releases, Test #35 is disabled.
7
FAIL
The translation update failed. There may be an internal software
error. The ringer update was not performed because of this failure.
1. Retry the command at 1-minute intervals a maximum of 5 times.
8
FAIL
This does not indicate a hardware problem. There may be an
internal software error. The ringer update failed.
1. Retry the command at 1-minute intervals a maximum of 5 times.
PASS
The software and the port processor have the same status.
User-reported troubles on this port should be investigated by using
other port tests, by examining station wiring, or by examining the
station.
Table 436.
TEST #48 Station Present Test
Error
Code
Test
Result
Description/Recommendation
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000
ABORT
System resources required to run this test are not available. The port
may be busy with a valid call. Use the display port UUCSSpp
command to determine the station extension. Use the status station
command to determine the service state of the port. If the service
state indicates that the port is in use. Wait until the port is idle.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Table 435.
TEST #36 Station Status and Translation Audits and Updates —
Continued
Error
Code
Test
Result
Description/ Recommendation
Continued on next page