DS1-BD (DS1 Interface Circuit Pack)
Issue 5 October 2002
1141
555-233-119
The list measurements ds1 summary command will display the length of time the
test ran (Test Duration field) and number of bit errors detected (Loopback/Span
Test Bit-Error Count field).
To restore the trunks or ports on the TN767E DS1 Interface circuit pack to the
in-service state, execute the release board command.
Table 243.
TEST #1216 End Loopback/Span Test
Error
Code
Test
Result
Description/ Recommendation
ABORT
Internal system error
1. Retry the test ds1-loop UUCSS end-loopback/span-test command at
1-minute intervals a maximum of 5 times.
1005
ABORT
End Loopback/Span Test cannot be executed in the current configuration. To
run this, the TN767E or later suffix DS1 must be administered for 24-channel
operation. The "Bit Rate" field on the DS1 circuit pack administration form
must be set to "1.544" for 24-channel operation.
1015
ABORT
Ports on the DS1 Interface circuit pack have not been busied out to
out-of-service.
1. Enter the busyout board UUCSS command to put all trunks or ports of
the DS1 Interface circuit pack into the out-of-service state.
2. Retry the command.
ABORT
Internal system error
2100
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
Continued on next page