Basic Operation
R&S
®
Cable Rider ZPH
58
User Manual 1321.0950.02 ─ 07
2. Select the calibration kit model that you require.
The R&S Cable Rider ZPH loads the selected calibration kit model which is taken
in for consideration during the calibration.
For more information, see
Chapter 7.1.7.2, "Calibration Methods"
,
on page 138
and
Chapter 7.1.7.3, "Calibration Kit"
,
on page 140.
You can also define new calibration kit models with the R&S InstrumentView software
and then transfer them to the R&S Cable Rider ZPH. For more information on creating
the calibration kit models, refer to the documentation of the R&S InstrumentView soft-
ware package.
4.2.12
Resetting the R&S Cable Rider ZPH
You can either preset the R&S Cable Rider ZPH or reset it to factory settings.
Presetting the R&S Cable Rider ZPH
The [PRESET] key resets the R&S Cable Rider ZPH to the default setup of the cur-
rently active operating mode.
This default setup allows you to define the instrument with a new configuration based
on a defined measurement parameter without using parameters from a previous mea-
surement unintentionally still being active.
► Press the [PRESET]
key.
Resetting the R&S Cable Rider ZPH
A "Reset to Factory Settings" resets the R&S Cable Rider ZPH to the factory defaults.
During a reset, the R&S Cable Rider ZPH restores the original configuration. It also
deletes all customized datasets (limit lines, standards, channel tables, transducer
Configuring the R&S Cable Rider ZPH
