Remote Commands
R&S
®
Cable Rider ZPH
337
User Manual 1321.0950.02 ─ 07
Each section describes the commands for one of the operating modes available in the
R&S Cable Rider ZPH, beginning with the description of common commands required
to operate the instrument. The structure is based on that of the R&S Cable Rider ZPH
user manual.
●
Chapter 14.6.1, "Common Commands"
,
on page 338
●
Chapter 14.6.2, "Remote Commands of the Cable and Antenna Analyzer"
,
on page 341
●
Chapter 14.6.3, "Remote Commands of the Spectrum Analyzer"
,
on page 387
●
Chapter 14.6.4, "Remote Commands of the Analog Modulation"
,
on page 459
●
Chapter 14.6.5, "Remote Commands of the Digital Modulation"
,
on page 473
●
Chapter 14.6.6, "Remote Commands of the Power Meter"
,
on page 492
Each section is subdivided into various tasks required to perform measurements with
the R&S Cable Rider ZPH, also based on the structure of the R&S Cable Rider ZPH
user manual. Some commands like those for controlling markers or configuring the fre-
quency axis are available for all operating modes. In that case, you can find a list of
these commands in the corresponding section.
Availability of commands
The cable and antenna test modes are implemented in the basic unit. For the other
modes, the corresponding options are required.
Following the remote control commands required to perform specific measurements,
you can find a description of general commands used to set up and control basic
instrument functions. These commands are independent of the operating mode. There-
fore they are listed separately.
●
Chapter 14.6.7, "File Management"
,
on page 498
●
Chapter 14.6.8, "Making and Storing Screenshots"
,
on page 504
●
Chapter 14.6.9, "Configuring Data Capture"
,
on page 505
●
Chapter 14.6.10, "Saving Events"
,
on page 507
●
Chapter 14.6.11, "Configuring the Instrument"
,
on page 509
●
Chapter 14.6.12, "Status Reporting System"
,
on page 524
All chapters begin with a list of commands available in the context of that chapter. Fol-
lowing that list, you can find a detailed description of all the commands.
All individual descriptions contain:
●
Complete notation and syntax of the command
●
Description of the effects of the command
●
A list of all parameters available for that command or the type of data the com-
mand returns in case of query commands
●
An example of how a program message would look like
●
The
*RST
value
An alphabetical list of all available commands is provided at the end of this manual.
Remote Control - Commands
