Remote Commands
R&S
®
Cable Rider ZPH
437
User Manual 1321.0950.02 ─ 07
CALCulate<1...2>:MARKer<1...6>:FUNCtion:POWer:PRESet:CHECk?
This command checks if the current settings are in line with the settings defined by the
standard selected with
CALCulate<1...2>:MARKer<1...6>:FUNCtion:POWer:
PRESet
on page 436.
The numeric suffix at CALculate and MARKer are irrelevant for this command.
Note that the command only checks those parameters that are defined by the stan-
dard.
This command is a query and therefore has no *RST value.
Return Value
0
The R&S Cable Rider ZPH settings violate a stan-
dard configuration
1
The R&S Cable Rider ZPH settings comply with the
standard.
The numeric suffix at CALculate and MARKer are irrelevant for this command.
Example:
CALC:MARK:FUNC:POW:PRES:CHEC?
Queries compliance to the standard currently in use.
Usage:
Query only
CALCulate<1...2>:MARKer<1...6>:FUNCtion:LEVel:ONCE
This command adjusts the reference level to the measured signal power.
This automatic routine makes sure that the signal power level does not overload the
R&S Cable Rider ZPH or limits the dynamic range by too small an S/N ratio.
To determine the best reference level, the R&S Cable Rider ZPH aborts current mea-
surements and performs a series of test sweeps. After it has finished the test, it contin-
ues with the actual measurement.
This command is an event and therefore has no *RST value and no query.
The numeric suffix at CALCulate is irrelevant for this command. The numeric suffix at
MARKer selects the marker.
Example:
CALC:MARK:FUNC:LEV:ONCE
Initiates an automatic level adjust routine.
Usage:
Event
CALCulate<1...2>:MARKer<1...6>:FUNCtion:POWer:RESult?
<arg0>
This command queries the results of power measurements.
To get a valid result, you have to perform a complete sweep with synchronization to the
sweep end before reading out the result. This is only possible in single sweep mode.
Remote Control - Commands
