Cable and Antenna Test Mode
R&S
®
Cable Rider ZPH
144
User Manual 1321.0950.02 ─ 07
4. Select the cable mode that you are testing.
The R&S Cable Rider ZPH loads the selected cable mode. Note that the selected
cable mode is also displayed in the
title bar
.
7.2.1.2
Clear Cable Model
1. For model .02, press the [DTF CONFIG] key.
For model .12, press the [DTF/BW] key.
2. Select the "Cable Config" softkey.
The R&S Cable Rider ZPH opens a submenu to select the cable model.
3. Select the "Clear Model" softkey.
The R&S Cable Rider ZPH unload the cable model from the measurement.
7.2.1.3
Creating a Cable Model
Temporary cable model
When you change any cable parameters or load another cable model, the temporary
cable model data is lost and you have to define it again if you have to perform further
measurements.
The R&S Cable Rider ZPH provides two ways to define customized cable models.
The first way is to define a cable model with the "Cable Model Editor" that is part of the
R&S InstrumentViewsoftware package. The R&S InstrumentView is delivered with the
R&S Cable Rider ZPH. With this software, you can define a cable model on a com-
puter and then transfer it to the instrument.
Configuring Cable and Antenna Tests
