Working with the Measurement Wizard
R&S
®
Cable Rider ZPH
118
User Manual 1321.0950.02 ─ 07
Measurement parameters
Descriptions
Comments
Comments about the measurement, e.g. the external con-
ditions during the measurement.
GPS Position
Displays the GPS information. See
Chapter 4.2.3, "Using
the GPS Receiver"
,
on page 45.
Cable Definition
Use Wizard
Cable Set-
tings
Select the usage of cable characteristics as defined in the
measurement set.
Select "On" to use the predefined cable characteristics or
"Off" to redefine the cable model and cable length in R&S
Cable Rider ZPH. In the case, if "On" is selected, the
parameters below will be locked.
Cable Model
Cable model that you perform the measurement on. You
can define a cable model with the R&S Cable Rider ZPH
software, but can also change the cable model on short
notice, if necessary. See
Chapter 7.2.1.3, "Creating a
Cable Model"
,
on page 144.
Clear Cable
Model
Deactivates the currently active cable model. See
Chap-
ter 7.2.1.2, "Clear Cable Model"
,
on page 144.
Cable Length
Length of the cable that you perform the measurement on.
Cable Settings
Default Cali-
bration
Calibration that was defined when creating the wizard set
in the R&S InstrumentView software.
Use Stored
Calibrations
If set to "On", the wizard uses the calibration stored in the
R&S Cable Rider ZPH. If set to "Off", the wizard uses the
calibration defined in the R&S InstrumentView software.
Measurement specification
The measurement specification dialog box displays the measurement step sequences
and the individual performed measurement status. See
Figure 6-3
.
► Select the "Meas Spec" softkey.
The R&S Cable Rider ZPH opens the "Meas Spec" dialog box.
Performing and Configuring Measurements
