Remote Commands
R&S
®
Cable Rider ZPH
345
User Manual 1321.0950.02 ─ 07
Parameters:
<DtfDistanceStop>
Numeric value in the range from 3 m (10 ft) to 1500 m (4921 ft)
The unit is either meter or feet, depending on your selection.
*RST:
1500 m (4921 ft)
Default unit: m
Example:
CALC:DTF:DIST:STOP 500m
Sets the end point of the measurement to 500 m.
14.6.2.2
Configuring the Vertical Axis
The following commands configure the vertical (level) axis and level parameters of the
active display.
Commands independent of the operating mode
Note that some of the commands for configuring the vertical axis are also valid for
other operating modes. If a command is available in another mode, it is indicated by
the list in the respective section.
List of commands
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:ADJust
.............................................. 345
DISPlay<1...2>:LOSS:REFerence
....................................................................................346
DISPlay<1...2>:LOSS:REFerence:POSition
...................................................................... 346
DISPlay<1...2>:LOSS:Y:SCALe
.......................................................................................346
DISPlay<1...2>:MAGNitude:REFerence
............................................................................347
DISPlay<1...2>:MAGNitude:REFerence:POSition
..............................................................347
DISPlay<1...2>:MAGNitude:Y:SCALe
...............................................................................347
DISPlay<1...2>:MAGNitude:Y:SPACing
............................................................................ 348
DISPlay<1...2>:PHASe:REFerence
..................................................................................348
DISPlay<1...2>:PHASe:UNWRap
.................................................................................... 348
DISPlay<1...2>:VSWR:Y:SCALe:MINimum
....................................................................... 349
DISPlay<1...2>:VSWR:Y:SCALe:MAXimum
...................................................................... 349
DISPlay<1...2>:VSWR:Y:SCALe
......................................................................................349
SOURce:TG:ATTenuation
............................................................................................... 350
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:ADJust
This command automatically scales the vertical axis for optimum display results.
This command is an event and therefore has no query and no *RST value.
The numeric suffix at DISPlay and TRACe are irrelevant for this command.
Example:
DISP:TRAC:Y:ADJ
Adjusts the y-axis.
Usage:
Event
Remote Control - Commands
