Remote Commands
R&S
®
Cable Rider ZPH
511
User Manual 1321.0950.02 ─ 07
List of commands
SYSTem:POSition:ALTitude?
...........................................................................................511
SYSTem:POSition:GPS:CONNected?
.............................................................................. 511
SYSTem:POSition:GPS:CORRection:FREQuency?
........................................................... 511
SYSTem:POSition:GPS:QUALity?
....................................................................................511
SYSTem:POSition:GPS:SATellites?
..................................................................................512
SYSTem:POSition:GPS[:STATe]
...................................................................................... 512
SYSTem:POSition:LATitude?
...........................................................................................512
SYSTem:POSition:LONGitude?
....................................................................................... 512
SYSTem:POSition:VALid?
...............................................................................................512
SYSTem:POSition:ALTitude?
This command queries the altitude of the current position of the R&S Cable Rider ZPH.
Example:
SYST:POS:ALT?
Return value would be, for example, 554.1.
Usage:
Query only
SYSTem:POSition:GPS:CONNected?
This command queries if the R&S Cable Rider ZPH is currently connected to the GPS
receiver.
Example:
SYST:POS:GPS:CONN?
Usage:
Query only
SYSTem:POSition:GPS:CORRection:FREQuency?
This command queries the frequency correction factor.
The R&S Cable Rider ZPH calculates this factor from a reference signal provided by
the GPS receiver. The reference signal is used to determine the deviation of the inter-
nal clock of the instrument. The deviation can be turned into a correction factor for the
measured frequency.
Example:
SYST:POS:GPS:CORR:FREQ?
Queries the frequency correction factor.
Usage:
Query only
SYSTem:POSition:GPS:QUALity?
This command queries the quality of the GPS signal.
Example:
SYST:POS:GPS:QUAL?
Usage:
Query only
Remote Control - Commands
