Working with the Measurement Wizard
R&S
®
Cable Rider ZPH
120
User Manual 1321.0950.02 ─ 07
Figure 6-4: Perform wizard measurement dialog box
1 = Image of a measurement step defined in the R&S InstrumentView software package.
2 = Wizard message box
3 = See
Table 6-2
1. Select the "Start Meas" softkey.
If you have not yet calibrated the R&S Cable Rider ZPH for the measurement, it
asks you to perform the calibration routine. The stages of the calibration depend on
the defined calibration routine. See
Chapter 7.1.7, "Calibrating Measurements"
,
on page 137 and
"Calibration data"
on page 119.
After having successfully calibrated the R&S Cable Rider ZPH, it starts to go
through the measurements that are part of the measurement wizard set. The
sequence of the measurements is defined in the R&S InstrumentView.
Before the start of each measurement, the R&S Cable Rider ZPH displays a mas-
sage "Preparing New Measurement" in the wizard message box.
The message box contains information and instructions on how to prepare and per-
form the measurement that you have defined in the R&S InstrumentView software.
2. At each measurement step, you have several options:
● Select the "Continue" softkey.
The R&S Cable Rider ZPH finishes the current measurement and opens the
measurement wizard dialog box. See
Figure 6-5
Performing and Configuring Measurements
