Remote Commands
R&S
®
Cable Rider ZPH
518
User Manual 1321.0950.02 ─ 07
Example:
INPut:IMP 75;PAD RAZ
Selects 75 Ω input impedance and the R&S RAZ as the match-
ing pad.
[SENSe:]ROSCillator:SOURce
<Format>
This command selects the source of the frequency reference oscillator.
If you use an external reference signal, make sure to connect the signal to the Ext Ref
BNC connector of the R&S Cable Rider ZPH.
Parameters:
<Format>
INTernal | EXTernal
INTernal
Internal reference.
EXTernal
External reference.
Example:
ROSC:SOUR EXT
Activates external source as reference signal.
SYSTem:ACCessory
<Accessory>
This command queries the type of measurement accessory, if one is connected to the
R&S Cable Rider ZPH (for example a power sensor).
Parameters:
<Accessory>
Z1 | Z2 | Z3 | Z14 | Z18 | Z44 | TS_emf | ZN_Z103 | NONE |
UNKNown
Name of the accessory.
Example:
SYST:ACC?
Queries connected measurement accessories.
SYSTem:ACCessory:AUTO
<State>
This command turns automatic detection of connected measurement accessories on
and off.
Parameters:
<State>
ON | OFF
Example:
SYST:ACC:AUTO ON
Turns on automatic accessory detection.
SYSTem:BNC:MODE
<BNCUsage>
This command configures the BNC sockets.
Parameters:
<BNCUsage>
REFerence | TRIGger | BIAS
Remote Control - Commands
