Remote Commands
R&S
®
Cable Rider ZPH
350
User Manual 1321.0950.02 ─ 07
Suffix:
<1...2>
.
1...2
Parameters:
<DisplayRange>
Numeric value in the range from 1.1 to 71.
The number you enter is rounded up to the next possible display
range. For example, if you enter 5, the R&S Cable Rider ZPH
automatically sets the display range to 1...6.
*RST:
1...21
Example:
DISP:VSWR:Y:SCAL 50
Defines a display range of 1...71.
SOURce:TG:ATTenuation
<OutputLevel>
This command defines the relative output level of the tracking generator.
Parameters:
<OutputLevel>
Range:
0 to 40
*RST:
0
Default unit: DB
Example:
SOUR:TG:ATT 40
Sets the attenuation to 40 dB and therefore an output level of –
40 dBm
14.6.2.3
Setting the Bandwidth
The following commands configure the filter bandwidths of the R&S Cable Rider ZPH.
Note that both groups of commands (
BANDwidth
and
BWIDth
) are the same.
List of commands
[SENSe:]BANDwidth[:RESolution]
................................................................................... 350
[SENSe:]BWIDth[:RESolution]
.........................................................................................351
[SENSe:]BANDwidth[:RESolution]:AUTO
..........................................................................351
[SENSe:]BWIDth[:RESolution]:AUTO
............................................................................... 351
[SENSe:]BANDwidth[:RESolution]
<ResolutionBW>
This command defines the resolution bandwidth.
Parameters:
<ResolutionBW>
Range:
1 Hz to 3 MHz
*RST:
- (AUTO is set to ON)
Default unit: GHz
Example:
BAND 100 kHz
Sets the resolution bandwidth to 100 kHz.
Remote Control - Commands
