Remote Commands
R&S
®
Cable Rider ZPH
382
User Manual 1321.0950.02 ─ 07
1
Limit check pass.
Example:
CALC:TRAC:LIM:VSWR:FAIL?
Queries the results of the limit check.
Usage:
Query only
CALCulate<1...2>:TRACe:VSWR:MAX:RESult?
This command queries the maximum VSWR measurement result.
The command is available when the calculation of the VSWR has been turned on with
CALCulate<1...2>:TRACe:VSWR:MAX[:STATe]
on page 378.
The numeric suffix at CALCulate is irrelevant for this command.
Suffix:
<1...2>
.
1...2
Parameters:
<Return values>
Maximum VSWR (no unit)
Example:
CALC:TRAC:VSWR:MAX:STAT ON
CALC:TRAC:VSWR:MAX:RES?
Queries the maximum VSWR.
Usage:
Query only
Calibrating the Measurement
The following commands control calibration of cable measurements.
List of commands
CALibration<1...2>:ABORt
.............................................................................................. 382
CALibration<1...2>:ATTenuation:STATus?
.........................................................................383
CALibration<1...2>:CONTinue?
....................................................................................... 383
CALibration<1...2>:MODE?
.............................................................................................383
CALibration<1...2>:STARt?
............................................................................................. 384
CALibration<1...2>:STATus?
........................................................................................... 385
CALibration<1...2>:ABORt
This command aborts calibration.
The numeric suffix at CALibration is irrelevant for this command.
This command is an event and therefore has no query and no *RST value.
Suffix:
<1...2>
.
1...2
Example:
CAL:ABOR
Aborts calibration.
Remote Control - Commands
