Remote Commands
R&S
®
Cable Rider ZPH
426
User Manual 1321.0950.02 ─ 07
List of commands
CALCulate<1...2>:DLINe
................................................................................................ 426
CALCulate<1...2>:DLINe:STATe
...................................................................................... 426
CALCulate<1...2>:DLINe
<LinePosition>
This command defines the position of a display line.
The numeric suffix at CALCulate is irrelevant for this command.
Suffix:
<1...2>
.
1...2
Parameters:
<LinePosition>
Numeric value with a variable range and unit.
You can use any unit you want, the R&S Cable Rider ZPH then
converts the unit to the currently selected unit. If you omit a unit,
the R&S Cable Rider ZPH uses the currently selected unit.
*RST:
– (STATe to OFF)
Default unit: dBm
Example:
CALC:DLIN –20dBm
Sets the display line threshold to -20 dBm.
CALCulate<1...2>:DLINe:STATe
<State>
This command turns display lines on and off.
The numeric suffix at CALCulate is irrelevant for this command.
Suffix:
<1...2>
.
1...2
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:DLIN:STAT OFF
Turns on the display line.
Limit Lines
The following commands define limit lines and perform the corresponding limit checks.
List of commands
CALCulate<1...2>:LIMit<1...2>:BEEP[:STATe]
................................................................... 427
CALCulate<1...2>:LIMit<1...2>:COMMent?
....................................................................... 427
CALCulate<1...2>:LIMit<1...2>:DEFine
.............................................................................428
CALCulate<1...2>:LIMit<1...2>:DELete
.............................................................................429
CALCulate<1...2>:DLINe
................................................................................................ 429
CALCulate<1...2>:DLINe:STATe
...................................................................................... 429
CALCulate<1...2>:LIMit<1...2>:FAIL?
............................................................................... 430
Remote Control - Commands
