Basic Operation
R&S
®
Cable Rider ZPH
35
User Manual 1321.0950.02 ─ 07
The
Invalid trace indicator
is displayed below the S11 result format and calibration sta-
tus.
For information of result format and calibration status, see
Chapter 7.1, "Performing
Cable and Antenna Measurements"
,
on page 128 and
Chapter 7.1.7.1, "Calibration
States"
,
on page 138.
For information of the internal DC bias status, see
Configuring the BIAS output port
.
For information of markers, display line and limit lines, see
Chapter 7.3, "Analyzing
Measurement Results"
,
on page 155.
4.1.4
Parameter View
The "Parameter view" contains the important hardware setting parameters used in the
measurement.
It is located at the right side and bottom section of the screen layout. See
Figure 4-1
.
You can select any parameter in the "Parameter view" to adjust the configurations of
the hardware settings. See details of each of the parameter in
Chapter 7.2.2, "Config-
uring the Horizontal Axis"
,
on page 146 and
Chapter 7.2.3, "Configuring the Vertical
Axis"
,
on page 150.
Parameter
Description
"Center", "Start", "Stop"
Function-specific displays depending on the softkey
indicated in the softkey label. It is used to configure
one of the following:
●
center frequency, start or stop frequency for the
measurement.
●
start or stop cable length for measurement.
See
Chapter 7.2.2, "Configuring the Horizontal
Axis"
,
on page 146.
"Span"
Configure the frequency span of the measurement.
See
Chapter 7.2.2.1, "Setting the Frequency Range
for DTF Measurements"
,
on page 147.
Screen Layout and Elements
