Remote Commands
R&S
®
Cable Rider ZPH
385
User Manual 1321.0950.02 ─ 07
CALibration<1...2>:STATus?
This command queries if the R&S Cable Rider ZPH is fully calibrated for the current
measurement.
The numeric suffix at CALibration is irrelevant for this command.
This command is a query and therefore has no *RST value.
Suffix:
<1...2>
.
1...2
Parameters:
<Return values>
NORMalized | APPRoximate
NORMalized
Full factory or user calibration
APPRoximate
Approximate calibration: measurement uncertainty must be
anticipated
Example:
CAL:STAT?
Queries the calibration status of the R&S Cable Rider ZPH.
Usage:
Query only
Working with a DTF List
The following commands configure the DTF peak list. The peak list is available for DTF
measurements only.
List of commands
CALCulate<1...2>:DTF:CABLe:LENGth
............................................................................385
CALCulate<1...2>:TRANsform:DTFault:PEAK:COUNt?
......................................................386
CALCulate<1...2>:TRANsform:DTFault:PEAK:DATA<1...10>?
............................................ 386
CALCulate<1...2>:TRANsform:DTFault:PEAK:STATe
.........................................................386
CALCulate<1...2>:TRANsform:DTFault:PEAK:THReshold
..................................................387
CALCulate<1...2>:MARKer<1...6>:FUNCtion:DTF:PEAK:THReshold
.................................. 387
CALCulate<1...2>:DTF:CABLe:LENGth
<CableLength>
This command sets the cable length.
Suffix:
<1...2>
.
1...2
Parameters for setting and query:
<CableLength>
Numeric value in the range from 3 m to 1500 m.
*RST:
20 m
Default unit: M
Example:
CALCulate:DTF:CAB:LENG 2 M
Sets the cable length to 2 meter.
Remote Control - Commands
