Remote Commands
R&S
®
Cable Rider ZPH
361
User Manual 1321.0950.02 ─ 07
<1...6>
1...6
Parameters:
<MarkerFormat>
NORMal | RPDB | RPL | RSCalar | IMPedance | ADMittance |
NIMPedance | NADMittance
See table below for supported parameters.
*RST:
NORMal
ADMittance
admittance in complex format (real + imaginary)
IMPedance
impedance in complex format (real + imaginary)
NADMittance
standardized admittance in complex format (real +
imaginary)
NIMPedance
standardized impedance in complex format (real +
imaginary)
NORMal
normal marker
RPDB
reflection coefficient in complex format (magnitude
(dB) + phase)
RPL
reflection coefficient in complex format (magnitude
(lin) + phase
RSCalar
reflection coefficient in complex format (real + imagi-
nary)
CALCulate<1...2>:MARKer<1...6>:X
<FrequencyOrTime>
This command positions a marker on a particular coordinate on the horizontal axis.
If one or more delta markers (2 to 6) are already active, the command turns these delta
markers into normal markers.
Note that it is possible to place the marker outside the visible trace. In that case, this
value is invalid.
If necessary, the corresponding delta marker is activated first.
The numeric suffix at CALCulate is irrelevant for this command. The numeric suffix at
MARKer selects the marker.
Parameters:
<FrequencyOrTime> Indicates the coordinate on the horizontal axis.
The unit in spectrum analyzer mode depends on the measure-
ment, e.g. Hz for measurements in the frequency domain and
seconds for measurements in the time domain.
Range:
Maximum span.
Default unit: GHz
Example:
CALC:MARK2:X 10.7MHz
Positions marker 2 to frequency 10.7 MHz.
Remote Control - Commands
