Remote Commands
R&S
®
Cable Rider ZPH
507
User Manual 1321.0950.02 ─ 07
Example:
SYST:CAPT:SCR ON
Includes screenshots into the data capture.
14.6.10
Saving Events
The following commands configure the circumstances under which the R&S Cable
Rider ZPH saves events.
These commands are independent from the operating mode.
Using the commands requires a GPS receiver and a storage device (SD card or mem-
ory stick).
List of commands
SYSTem:SOEVent:DISTance:INTerval
..............................................................................507
SYSTem:SOEVent:LIMits:MODE
..................................................................................... 507
SYSTem:SOEVent:RECording:STORage
......................................................................... 508
SYSTem:SOEVent:SOURce
............................................................................................508
SYSTem:SOEVent:TIME:INTerval
.................................................................................... 508
SYSTem:SOEVent[:STATe]
............................................................................................. 509
SYSTem:SOEVent:DISTance:INTerval
<Seconds>
This command defines a distance that you must cover before the R&S Cable Rider
ZPH saves another coordinate.
Parameters:
<Seconds>
Distance between one coordinate and the next.
*RST:
1 m
Example:
SYST:SOEV ON
Turns on saving coordinates on an event.
SYST:SOEV:REC:STOR USB
Selects a USB device as the storage device.
SYST:SOEV:SOUR DIST
SYST:SOEV:DIST:INT 5
Saves the coordinates every 5 m.
SYSTem:SOEVent:LIMits:MODE
<arg0>
This command selects the limit check condition that must occur in order to save a coor-
dinate.
Parameters:
<arg0>
STARtonfail | STOPonfail | FAILonly
STARtonfail
Starts to save all sweeps from the moment a limit check fails.
STOPonfail
Saves all sweeps until a limit check fails.
Remote Control - Commands
