Remote Commands
R&S
®
Cable Rider ZPH
522
User Manual 1321.0950.02 ─ 07
SYSTem:PRESet
Resets the R&S Cable Rider ZPH to its default state or a state defined by the user,
depending on SYSTem:PRESet:MODE.
This command is an event and therefore has no *RST value and no query.
Example:
SYST:PRES
Usage:
Event
SYSTem:PRESet:CALibration:DISCard
<Disc>
This command turns the mechanism that discards or keeps user calibration after a pre-
set on and off.
Parameters:
<Disc>
ON | OFF
ON
Discards user calibration after a preset.
OFF
Keep user calibration after a preset.
*RST:
OFF
Example:
SYST:PRES:CAL:DISC ON
Discards user calibration after a preset.
SYSTem:PRESet:FACTory
This command initiates an instrument reset back to factory settings.
This command is an event and therefore has no query and no *RST value.
Example:
SYST:PRES:FACT
Resets the R&S Cable Rider ZPH to its factory settings.
Usage:
Event
SYSTem:PRESet:MODE
<Mode>
This command selects the preset mode.
Parameters:
<Mode>
DEFault | USER
DEFault
Default preset state.
USER
User defined preset state.
Example:
SYST:PRES:MODE USER
Selects a user defined preset.
Remote Control - Commands
