Getting Started
R&S
®
Cable Rider ZPH
18
User Manual 1321.0950.02 ─ 07
Risk of electrostatic discharge (ESD)
Electrostatic discharge (ESD) can cause damage to the electronic components of the
instrument and the device under test (DUT). ESD is most likely to occur when you con-
nect or disconnect a DUT or test fixture to the instrument's test ports. To prevent ESD,
use a wrist strap and cord and connect yourself to the ground, or use a conductive
floor mat and heel strap combination.
For details, refer to the basic safety instructions delivered as a printed brochure with
the instrument.
Risk of instrument damage during operation
An unsuitable operating site or test setup can cause damage to the instrument and to
connected devices. Ensure the following operating conditions before you switch on the
instrument:
●
The instrument is dry and shows no sign of condensation.
●
The instrument is positioned as described in the following sections.
●
The ambient temperature does not exceed the range specified in the data sheet.
●
Signal levels at the input connectors are all within the specified ranges.
●
Signal outputs are correctly connected and are not overloaded.
EMI impact on measurement results
Electromagnetic interference (EMI) may affect the measurement results.
To suppress generated electromagnetic interference (EMI):
●
Use suitable shielded cables of high quality. For example, use double-shielded RF
and LAN cables.
●
Always terminate open cable ends.
●
Note the EMC classification in the data sheet.
3.1.1.1
Unpacking and Checking the Instrument
Unpack the R&S Cable Rider ZPH carefully and check the contents of the package.
●
Check the equipment for completeness using the delivery note and the accessory
lists for the various items.
●
Check the instrument for any damage. If there is damage, immediately contact the
carrier who delivered the instrument.
●
Keep the box and packing material.
Preparing for Use
