Remote Commands
R&S
®
Cable Rider ZPH
399
User Manual 1321.0950.02 ─ 07
SOURce:TG:FREQuency:OFFSet
<TgSourceFrequencyOffset>
This command defines a mathematical frequency offset for the tracking generator
Parameters:
TgSrcFreqOffset
Frequency offset of the TG source.
Range:
0 to 1.95
*RST:
0
Default unit: GHZ
Example:
SOUR:TG:FREQ:OFFS 1
Generates a tracking generator signal with an offset frequency
of 1 GHz.
SOURce:TG:POWer
<TgOutputLevel>
This command defines the absolute output level of the tracking generator.
Parameters:
<TgOutputLevel>
Numeric value in the range from 0 to -40 dBm.
*RST:
0
Default unit: dBm
Example:
SOUR:TG:POW -20
Defines an output level of -20 dBm.
SOURce:TG[:STATe]
<TgSourceState>
This command turns the tracking generator on and off.
Available when zero span has been turned on, for example with
SOURce:TG:AUTO
.
Parameters:
<TgSourceState>
ON | OFF
*RST:
OFF
Example:
SOUR:TG:AUTO ON
SOUR:TG OFF
Stops the generation of a CW signal.
14.6.3.4
Setting the Bandwidth
The following commands configure the filter bandwidths of the R&S Cable Rider ZPH.
Note that both groups of commands (
BANDwidth
and
BWIDth
) are the same.
List of commands
[SENSe:]BANDwidth[:RESolution]
................................................................................... 400
[SENSe:]BWIDth[:RESolution]
.........................................................................................400
[SENSe:]BANDwidth[:RESolution]:AUTO
..........................................................................400
[SENSe:]BWIDth[:RESolution]:AUTO
............................................................................... 400
[SENSe:]BANDwidth:VIDeo
............................................................................................ 401
Remote Control - Commands
