Rohde & Schwarz 1321.1211.02, User Manual

Page: 540 / 621

Remote Commands
R&S
®
Cable Rider ZPH
533 User Manual 1321.0950.02 ─ 07
larly since faulty commands from the controller to the instrument are recorded there as
well.
14.6.12.6 Reset Values of the Status Reporting System
Table 14-13 contains the different commands and events causing the status reporting
system to be reset. None of the commands, except
*RST
and
SYSTem:PRESet
, influ-
ences the functional instrument settings. In particular, DCL does not change the instru-
ment settings.
Table 14-13: Resetting the status reporting system
Event Switching
on supply
voltage DCL, SDC
Power-On-
Status-Clear (Device
Clear,
Selected
Device
Clear) *RST or
SYS-
Tem:PRE-
Set STA-
Tus:PRESet *CLS
Effect 0 1
Clear STB, ESR - yes - - - yes
Clear SRE, ESE - yes - - - -
Clear PPE - yes - - - -
Clear EVENt parts of
the registers - yes - - - yes
Clear ENABle parts
of all OPERation and
QUEStionable regis-
ters; Fill ENABle
parts of all other reg-
isters with "1". - yes - - yes -
Fill PTRansition parts
with "1"; Clear
NTRansition parts - yes - - yes -
Clear error queue yes yes - - - yes
Clear output buffer yes yes yes 1) 1) 1)
Clear command pro-
cessing and input
buffer yes yes yes - - -
1) Every command being the first in a program message, i.e., immediately following a
<PROGRAM MESSAGE TERMINATOR> clears the output buffer.
14.6.12.7 Remote Commands of the Status Reporting System
The following commands control the status-reporting system
*RST
does not influence
the status registers.
Remote Control - Commands