Remote Commands
R&S
®
Cable Rider ZPH
392
User Manual 1321.0950.02 ─ 07
Parameters:
<StartFrequency>
Range:
Depends on the operating mode and is specified in
the datasheet.
*RST:
0 Hz
Default unit: GHz
Example:
FREQ:STAR 20MHz
Defines a start frequency of 20 MHz.
[SENSe:]FREQuency:STOP
<StopFrequency>
This command defines the stop frequency for measurements in the frequency domain
(span > 0).
Parameters:
<StopFrequency>
Range:
Depends on the operating mode and is specified in
the datasheet.
*RST:
fmax
Default unit: GHz
Example:
FREQ:STOP 2000MHz
Defines a stop frequency of 2 GHz.
14.6.3.2
Configuring the Vertical Axis
The following commands configure the vertical (level) axis and level parameters of the
active display.
Commands independent of the operating mode
Note that some of the commands for configuring the vertical axis are also valid for
other operating modes. If a command is available in another mode, it is indicated by
the list in the respective section.
List of commands
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:ADJust
.............................................. 393
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y:SPACing
.........................................................393
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]
......................................................... 393
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:RLEVel
..............................................393
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:RLEVel:OFFSet
................................. 394
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:RPOSition
......................................... 394
INPut:ATTenuation
......................................................................................................... 394
INPut:ATTenuation:MODE
...............................................................................................395
INPut:ATTenuation:AUTO
............................................................................................... 395
INPut:GAIN:STATe
......................................................................................................... 395
INPut:IMPedance
...........................................................................................................396
[SENSe:]CORRection:TRANsducer<1...2>[:STATe]
........................................................... 396
[SENSe:]CORRection:TRANsducer<1...2>:SELect
............................................................396
[SENSe:]CORRection:TRANsducer<1...2>:UNIT?
............................................................. 396
UNIT<1...2>:POWer
....................................................................................................... 397
Remote Control - Commands
