Remote Commands
R&S
®
Cable Rider ZPH
456
User Manual 1321.0950.02 ─ 07
Measuring the AM Modulation Depth
The following commands configure AM Modulation Depth measurements. To perform
the actual measurement, use the commands described in section
Chapter 14.6.3.5,
"Performing and Triggering Measurements"
,
on page 402.
List of commands
CALCulate<1...2>:MARKer<1...6>:FUNCtion:MDEPth[:STATe]
........................................... 456
CALCulate<1...2>:MARKer<1...6>:FUNCtion:MDEPth:RESult?
.......................................... 456
CALCulate<1...2>:MARKer<1...6>:FUNCtion:MDEPth[:STATe]
<State>
This command turns the AM Modulation Depth measurement on and off.
The suffix at CALCulate and MARKer are irrelevant for this command.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:MARK:FUNC:MDEP ON
Activates the AM modulation depth measurement.
CALCulate<1...2>:MARKer<1...6>:FUNCtion:MDEPth:RESult?
This command queries the results of the AM modulation depth measurement.
The suffix at CALCulate and MARKer are irrelevant for this command.
Parameters:
<Return values>
<ModulationDepth>
Modulation depth in %.
Example:
CALC:MARK:FUNC:MDEP:RES?
Queries the AM modulation depth.
Usage:
Query only
Measuring the Spectrum Emission Mask
The following commands configure Spectrum Emission Mask (SEM) measurements..
To perform the actual measurement, use the commands described in section
Chap-
ter 14.6.3.5, "Performing and Triggering Measurements"
,
on page 402.
List of commands
CALCulate<1...2>:MARKer<1...6>:FUNCtion:TXPower:RESult?
......................................... 457
[SENSe:]ESPectrum:PRESet[:STANdard]
.........................................................................457
[SENSe:]ESPectrum:PRESet:SETTings
........................................................................... 457
[SENSe:]SWEep:MODE
................................................................................................. 457
Remote Control - Commands
