Spectrum Analyzer Mode
R&S
®
Cable Rider ZPH
211
User Manual 1321.0950.02 ─ 07
lyzer mode, or an application other than the Spectrum application, check the specific
application or mode description for settings that may deviate from these common set-
tings.
●
Configuration Overview
......................................................................................... 211
●
Configuring the Horizontal Axis
.............................................................................212
●
Configuring the Vertical Axis
................................................................................. 215
●
Configuring the Tracking Generator
......................................................................220
●
Setting Bandwidths
............................................................................................... 221
●
Configuring and Triggering the Sweep
..................................................................224
●
Working with Traces
..............................................................................................229
●
Using Markers
.......................................................................................................234
●
Using Display Lines
...............................................................................................245
●
Using Limit Lines
...................................................................................................245
8.2.1
Configuration Overview
The "Configuration Overview" provides an overview on the most important currently
defined settings for the spectrum measurement. See
Chapter 4.1.4.1, "Configuration
Overview"
,
on page 36. It is displayed when you select the "Config Overview" icon,
which is available at the bottom of "Parameter View". See
Chapter 4.1.4, "Parameter
View"
,
on page 35.
The "Configuration Overview" provides quick access and allows easy configuration on
the parameters that affect the spectrum measurement from input to signal processing
to output and signal analysis by stepping through each of the following dialog boxes:
●
"Input"
See
Chapter 8.2.3.7, "Setting the Input Impedance"
,
on page 219.
●
"Amplitude"
See
Chapter 8.2.3, "Configuring the Vertical Axis"
,
on page 215.
●
"Frequency"
See
Chapter 8.2.2, "Configuring the Horizontal Axis"
,
on page 212.
Configuring Spectrum Measurements
