Remote Commands
R&S
®
Cable Rider ZPH
440
User Manual 1321.0950.02 ─ 07
CALCulate<1...2>:MARKer<1...6>:FUNCtion:CPOWer:UNIT
<Unit>
This command selects the unit of the vertical axis for channel power measurements.
The numeric suffix at CALculate and MARKer are irrelevant for this command.
Suffix:
<1...2>
.
1...2
<1...6>
1...6
Parameters:
<Unit>
DBM | DBMV | DBUV | DUVE | DMVE | VEMF | DBUA | VOLT |
WATT | DUVM | DUAM | V | W | V_M | W_M2
*RST:
dBm
Example:
CALC:MARK:FUNC:CPOW:UNIT DBM
Sets the unit to dBm.
CALCulate<1...2>:MARKer<1...6>:FUNCtion:POWer:RESult:PHZ
<State>
This command turns the display of the channel power per Hertz on and off.
The numeric suffix at CALculate and MARKer are irrelevant for this command.
Parameters:
<State>
ON |OFF
*RST:
dBm
Example:
CALC:MARK:FUNC:POW:RES:PHZ ON
Displays the measured Channel Power / Hz.
Measuring the Occupied Bandwidth
The following commands configure the measurement of the Occupied Bandwidth. To
perform the actual measurement, use the commands described in section
Chap-
ter 14.6.3.5, "Performing and Triggering Measurements"
,
on page 402.
List of commands
CALCulate<1...2>:MARKer<1...6>:FUNCtion:OBAN:BANDwidth
.........................................440
CALCulate<1...2>:MARKer<1...6>:FUNCtion:OBAN:BANDwidth:PCT
................................. 441
CALCulate<1...2>:MARKer<1...6>:FUNCtion:OBW:BANDwidth
.......................................... 441
CALCulate<1...2>:MARKer<1...6>:FUNCtion:OBW:BANDwidth:PCT
...................................441
CALCulate<1...2>:MARKer<1...6>:FUNCtion:OBAN:BANDwidth
<ChannelBW>
This command defines the channel bandwidth for occupied bandwidth measurements.
Instead of OBANwidth, you can also use the alias OBWidth.
The numeric suffix at CALCulate and MARKer are irrelevant for this command.
Remote Control - Commands
