Remote Commands
R&S
®
Cable Rider ZPH
430
User Manual 1321.0950.02 ─ 07
Suffix:
<1...2>
.
1...2
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:DLIN:STAT OFF
Turns on the display line.
CALCulate<1...2>:LIMit<1...2>:FAIL?
This command queries the result of a limit check.
To get a valid result, you have to perform a complete sweep with synchronization to the
sweep end before reading out the result. This is only possible in single sweep mode.
The numeric suffix at CALCulate is irrelevant for this command. The numeric suffix at
LIMit selects the limit line.
Suffix:
<1...2>
.
1...2
<1...2>
1...2
Example:
INIT;*WAI
CALC:LIM1:FAIL?
Performs a measurement and queries the result of the check for
limit line 1.
Usage:
Query only
CALCulate<1...2>:LIMit<1...2>:STATe
<State>
This command turns a limit check on and off.
You can query the result of the limit check with
CALCulate<1...2>:
LIMit<1...2>:FAIL?
on page 374.
The numeric suffix at CALCulate is irrelevant for this command. The numeric suffix at
LIMit selects the limit line.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:LIM1:STAT ON
Switches on the limit check for limit line 1.
CALCulate<1...2>:LIMit<1...2>:UNIT:X?
This command queries the horizontal unit of a limit line.
This command is a query and therefore has no *RST value.
Remote Control - Commands
