Remote Commands
R&S
®
Cable Rider ZPH
377
User Manual 1321.0950.02 ─ 07
Example:
CALC:LIM1:UPP:THR -10DBM
Defines a threshold of -10 dBm.
14.6.2.8
Configuring and Using Measurement Functions
This chapter provides information on how to configure one-port measurements with the
signal source. The structure follows the order of the actual operation sequence used
when performing a measurement:
To perform the actual measurement, use the commands described in
Chapter 14.6.2.4,
"Performing Measurements"
,
on page 351.
●
Selecting the Cable Characteristics
...................................................................... 377
●
Selecting the Measurement Mode
........................................................................ 378
●
Selecting the Measurement Format
......................................................................378
●
Reading Out Measurement Results
......................................................................380
●
Calibrating the Measurement
................................................................................382
●
Working with a DTF List
........................................................................................ 385
Selecting the Cable Characteristics
The following commands define the cable characteristics for the cable you are testing.
List of commands
CALCulate<1...2>:DTF:CABLe:LENGth
............................................................................377
CALCulate<1...2>:DTF:CABLe:PRESet
............................................................................377
CALCulate<1...2>:DTF:CABLe:LENGth
<CableLength>
This command sets the cable length.
Suffix:
<1...2>
.
1...2
Parameters for setting and query:
<CableLength>
Numeric value in the range from 3 m to 1500 m.
*RST:
20 m
Default unit: M
Example:
CALCulate:DTF:CAB:LENG 2 M
Sets the cable length to 2 meter.
CALCulate<1...2>:DTF:CABLe:PRESet
<CableModel>
This command selects the cable model.
The numeric suffix at CALCulate is irrelevant for this command.
Suffix:
<1...2>
.
1...2
Parameters:
<CableModel>
String containing the filename of the cable model.
Remote Control - Commands
