Remote Commands
R&S
®
Cable Rider ZPH
509
User Manual 1321.0950.02 ─ 07
Parameters:
<Seconds>
Time that must pass between one coordinate and the next.
*RST:
1 s
Example:
SYST:SOEV ON
Turns on saving coordinates on an event.
SYST:SOEV:REC:STOR USB
Selects a USB device as the storage device.
SYST:SOEV:SOUR TIM
SYST:SOEV:TIME:INT 5
Saves the coordinates every 5 seconds.
SYSTem:SOEVent[:STATe]
<State>
This command turns saving of your current coordinates in case of certain events on
and off.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
See
SYSTem:SOEVent:DISTance:INTerval
on page 507
14.6.11
Configuring the Instrument
The following commands configure general instrument settings.
These commands are independent from the operating mode.
Contents
●
Mode Selection
..................................................................................................... 509
●
Controlling the GPS Receiver
............................................................................... 510
●
Display Configuration
............................................................................................513
●
Audio Settings
.......................................................................................................514
●
Setting up a Network Connection
..........................................................................515
●
System Settings
.................................................................................................... 517
14.6.11.1
Mode Selection
This chapter describes all commands that select the operating mode of the R&S Cable
Rider ZPH.
List of commands
INSTrument[:SELect]
......................................................................................................510
INSTrument:NSELect
..................................................................................................... 510
Remote Control - Commands
