Remote Commands
R&S
®
Cable Rider ZPH
474
User Manual 1321.0950.02 ─ 07
Parameters:
<CenterFrequency> Range:
Depends on the operating mode and is specified in
the data sheet.
*RST:
fmax /2 with fmax = maximum frequency
Default unit: MHz
Example:
FREQ:CENT 100MHz
Defines a center frequency of 100 MHz.
[SENSe:]FREQuency:CENTer:STEP
<Stepsize>
This command defines the center frequency step size.
Parameters:
<Stepsize>
Range:
1 Hz to fmax
*RST:
- (AUTO 0.1*SPAN is switched on)
Default unit: MHz
Example:
FREQ:CENT:STEP 120MHz
Defines a CF step size of 120 MHz.
[SENSe:]FREQuency:OFFSet
<FreqOffset>
This command defines a frequency offset.
Parameters:
<FreqOffset>
Range:
-100 GHz to 100 GHz
*RST:
0 Hz
Default unit: GHz
Example:
FREQ:OFFS 1GHZ
Defines a frequency offset of 1 GHz.
14.6.5.2
Setting the Amplitude
The following chapter describes command necessary to define the vertical scale such
as the x-axis deviation per division and settings affecting the amplitude of the measure-
ments.
List of commands
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:PDIVision
.......................................... 475
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:RPOSition
......................................... 475
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:RLEVel
..............................................475
INPut:ATTenuation
......................................................................................................... 476
INPut:ATTenuation:AUTO
............................................................................................... 476
INPut:ATTenuation:MODE
...............................................................................................476
INPut:GAIN:STATe
......................................................................................................... 477
INPut:IMPedance
...........................................................................................................477
INPut:IMPedance:PAD
....................................................................................................477
Remote Control - Commands
