Remote Commands
R&S
®
Cable Rider ZPH
450
User Manual 1321.0950.02 ─ 07
The suffix at CALCulate and LIMit are irrelevant for this command.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:LIM:ACP:ACH:STAT ON
Activates the relative limit check.
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel:ABSolute
<AbsoluteLimit>
This command defines the absolute limit for the adjacent channels.
Note that the absolute limit has no effect on the limit check if it is below the relative limit
(see
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel[:RELative]
on page 449). This mechanism allows automatic checking of the absolute basic values
of adjacent-channel power as defined in mobile radio standards.
The suffix at CALCulate and LIMit are irrelevant for this command.
Suffix:
<1...2>
.
1...2
<1...2>
1...2
Parameters:
<AbsoluteLimit>
Range:
-500 dBm to 500 dBm
Default unit: dBm
Example:
CALC:LIM:ACP:ACH:ABS -30
Sets the absolute limit to -30 dBm.
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel:ABSolute[:STATe]
<State>
This command turns the absolute limit check for the adjacent channel on and off.
You have to activate the general ACLR limit check before using this command with
CALCulate<1...2>:LIMit<1...2>:ACPower:STATe
on page 449 first.
The suffix at CALCulate and LIMit are irrelevant for this command.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
CALC:LIM:ACP:ACH:ABS:STAT ON
Activates the absolute limit check.
CALCulate<1...2>:LIMit<1...2>:ACPower:ACHannel:RESult?
This command queries the result of the limit check of the adjacent channels.
To get a valid result, you have to perform a complete sweep with synchronization to the
sweep end before reading out the result. This is only possible in single sweep mode.
Remote Control - Commands
