Basic Operation
R&S
®
Cable Rider ZPH
39
User Manual 1321.0950.02 ─ 07
4.2
Configuring the R&S Cable Rider ZPH
In the "Instrument Setup" dialog box, the R&S Cable Rider ZPH provides various gen-
eral settings that are independent of the operating mode of the R&S Cable Rider ZPH.
1. Press [SETUP] key.
2. Select the "Instrument Setup" softkey.
A corresponding dialog box to configure the instrument opens.
3. Select the item you want to modify.
●
Configuring the Hardware
....................................................................................... 39
●
Configuring Antennas
..............................................................................................41
●
Using the GPS Receiver
......................................................................................... 45
●
Configuring Date and Time
..................................................................................... 47
●
Selecting Regional Settings
.................................................................................... 48
●
Configuring the Display
...........................................................................................50
●
Configuring the Audio Output
..................................................................................52
●
Configuring Power Supply
.......................................................................................53
●
Internal Alignment
................................................................................................... 54
●
Performing Default Calibration
................................................................................56
●
Configuring Calibration Kit Model
............................................................................57
●
Resetting the R&S Cable Rider ZPH
...................................................................... 58
4.2.1
Configuring the Hardware
The hardware settings contain settings that control internal and connected hardware.
Using auto accessory detection
If you are using any accessories while working with the R&S Cable Rider ZPH, the
instrument is able to identify the connected hardware. To enable this setting:
1. In the "Instrument Setup" dialog box, select the "Auto Accessory Detection" item.
A drop-down menu to select the accessory detection opens.
2. Set the "Auto Accessory Detection" to "On".
Configuring the R&S Cable Rider ZPH
