Remote Commands
R&S
®
Cable Rider ZPH
454
User Manual 1321.0950.02 ─ 07
List of commands
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics[:STATe]
...................................... 454
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics:DISTortion?
................................ 454
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics:LIST?
.........................................454
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics:NHARmonics
..............................455
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics:PRESet
......................................455
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics[:STATe]
<State>
This command turns the harmonic distortion measurement on and off.
The suffix at CALCulate and MARKer are irrelevant for this command.
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
See
CALCulate<1...2>:MARKer<1...6>:FUNCtion:
HARMonics:PRESet
on page 455.
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics:DISTortion?
<ThdType>
This command queries the total harmonic distortion of the signal.
To get a valid result, you have to perform a complete sweep with synchronization to the
sweep end before reading out the result. This is only possible in single sweep mode.
This command is a query and therefore has no *RST value.
The suffix at CALCulate and MARKer are irrelevant for this command.
Parameters:
<ThdType>
TOTal
<Distortion%>,<DistortiondB>
Pair of values, one showing the THD in %, one in dB.
Example:
See
CALCulate<1...2>:MARKer<1...6>:FUNCtion:
HARMonics:PRESet
on page 455.
Usage:
Query only
CALCulate<1...2>:MARKer<1...6>:FUNCtion:HARMonics:LIST?
This command queries the position of the harmonics.
To get a valid result, you should perform a complete sweep in single sweep mode
before querying the results.
This command is a query and therefore has no *RST value.
The suffix at CALCulate and MARKer are irrelevant for this command.
Remote Control - Commands
