Remote Commands
R&S
®
Cable Rider ZPH
386
User Manual 1321.0950.02 ─ 07
CALCulate<1...2>:TRANsform:DTFault:PEAK:COUNt?
The following commands configure the DTF peak list. The peak list is available for DTF
measurements only.
The numeric suffix at CALibration is irrelevant for this command.
This command is a query and therefore has no *RST value.
Suffix:
<1...2>
.
1...2
Parameters:
<Return values>
<DTFListEntries>
Example:
CALC:TRAN:DTF:PEAK:COUN?Z
Queries the number of values in the DTF list.
Usage:
Query only
CALCulate<1...2>:TRANsform:DTFault:PEAK:DATA<1...10>?
This command queries the DTF list.
The numeric suffix at CALibration is irrelevant for this command and the number suffix
at DATA selects an entry in the DTF list.
This command is a query and therefore has no *RST value.
Suffix:
<1...2>
.
1...2
<1...10>
1...10
Parameters:
<Retrun values>
<distance>,<return loss>
The number of values depends on the number of peaks that
exceed the threshold you can set with
CALCulate<1...2>:
TRANsform:DTFault:PEAK:THReshold
on page 387.
Example:
CALC:TRAN:DTF:PEAK:RES2?
Reads out the second result in the DTF peak list.
Usage:
Query only
CALCulate<1...2>:TRANsform:DTFault:PEAK:STATe
<State>
This command turns the display of the DTF list on and off.
Suffix:
<1...2>
.
1...2
Parameters:
<State>
ON | OFF
ON
DTF list turns on.
Remote Control - Commands
