Remote Commands
R&S
®
Cable Rider ZPH
353
User Manual 1321.0950.02 ─ 07
Usage:
Setting only
Copies the trace into the memory.
DISPlay<1...2>[:WINDow]:TRACe<1...2>:MEMory<1...3>[:STATe]
<State>
This command turns the memory trace on and off.
The numeric suffix at DISPlay and MEMory are irrelevant for this command.
The numeric suffix at TRACe selects the number of the trace.
Suffix:
<1...2>
.
1...2
<1...2>
1...2
<1...3>
1...3
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
DISP:TRAC:MEM ON
Activates the memory trace.
DISPlay<1...2>[:WINDow]:TRACe<1...2>:MODE
<DisplayMode>
This command selects the trace mode.
If you are using the average, max hold or min hold trace mode, you can set the number
of measurements with
[SENSe:]SWEep:COUNt<SweepCount>
. Note that synchroni-
zation to the end of the average count is possible only in single sweep mode.
The numeric suffix at DISPlay is irrelevant for this command.
The numeric suffix at TRACe selects the number of the trace.
Parameters:
<DisplayMode>
WRITe | AVERage | MINHold | MAXHold | VIEW | FREeze |
INFinite
*RST:
WRITe
You can turn off the trace with
DISPlay<1...2>[:WINDow]:TRACe<1...2>[:STATe]
.
For more information, see chapter "Trace Mode".
Example:
SWE:CONT OFF
SWE:COUN 16
Turn on single sweep mode and sets the number of measure-
ments to 16.
DISP:TRAC:MODE MAXH
Activates MAXHold mode for the trace.
INIT;*WAI
Starts the measurement and waits for the end of the 16 sweeps.
Remote Control - Commands
